COMBICUT0 pages

Plasma Cutting, Punching and Forming
Soft-Switch Inverter Technology
More elements of Combicut
Technological flexibility, achievable cutting quality and
availability of the cutting system depend extensively on
the coordination between power source and plasma
cutting torch. Furthermore the productivity is influenced
significantly by the configuration of the power source.
Combination of Technologies
In a joint effort with the fine plasma technology firm
of Kjellberg, Boschert has developed a cost-effective alternative to combination punch/laser machines. Because of the advances in the fine plasma
technology in recent years, it is now possible to cut
even thin gauge sheet metal with very high quality.
Forming Tool
Forming of all types (e.g. louvering, knock-outs,
extrusions).
Intelligent Flexibility
Primary-switched electronic power sources offer optimal
possibilities for realising those demands. For this reason
the inverter power source HiFocus 160i was developed,
having the favourable working range of 4 to 160 A.
Producing complex inside and outside contours quickly at high quality is possible now also with Plasma.
Forming, offsetting, producing tongues, beads and even threads are the special domain of punching.
The Boschert Combicut unites the strength of all processes in one machine.
Productivity, Quality, Flexibility:
decisive in the competition
With the introduction of the HiFocus technology in
the year 2000, the world of plasma cutting saw a new
dimension of productivity, quality and variety of application, all based on the well-accepted FineFocus technology.
The exceptional quality of the cutting surfaces is characterized by dross free cuts, the fine tolerance of the
cut angle and straightness of cut, as well as smoothness of the cut edge and a positioning tolerance of
+/- 0.2 mm. In addition, repeatability is 0.03 mm and is
based on the technology of the HiFocus system, which
is known world-wide.
Marking Tool
Permanent part identification with embossing
tools and the marking option.
An additional advantage of the Boschert Combicut
is that our EccoLine, TWIN and TRI machines can
all be equipped with plasma. With this versatility
Boschert can meet all customer requirements.
Further advantages are:
•tSuperior cutting quality due to flexible adaption of the t
t process sequence to the cutting job
•tOptimized cutting process by fast control of the cutting t
t current, high dynamic response at small contours and t
t reduced run-in path, corner signal, etc.
•tLongetivity of consumables by controlled current ramp-t
t up and ramp-down during the start and stop sequence t
t and at piercing as well
•tRapid operation start because of extremely fast
t transition from pilot arc to main arc
•tSmall components, therefore low weight
•tImproved energy balance due to minimized switching tt
t losses
•tIndependent of mains
t fluctuations
•tAll cutting parameters
t controllable by serial
t interface; serial data
t transfer to PC for
t diagnostic purposes
Revotool
Heavy duty Revotool for max. 6 mm mild steel
with 8, 6 or 4 tools max. ø 16, 20 and 25 mm.
Ecco Line
TWIN
Separate machine frame
The separate frame allows independent and
vibration-free operation of the plasma head.
TRI
BOSCHERT