Atomizers0 pages

ULTRASONIC ATOMIZERS
Low and Medium Atomization Rate – 20 kHz and 40 kHz
From microliters to liters – continuous or intermittent
Dispenses material with virtually no overspray
Pressureless atomization – low velocity mist
Low cost atomizing probe replacement
Minimal atmospheric contamination
Virtually uncloggable

TYPICAL APPLICATIONS
VCX 134 ATFT – 40 kHz

Coating non-woven fabric, paper, etc.
Laboratory spray drying
Injecting moisture into a gas stream
Applying minute amount of oil, fragrance or
flavor onto a product
Injecting small volume of reagents into a reactor

GENERAL DESCRIPTION
Unlike conventional atomizing nozzles that rely on pressure and high-velocity motion to shear a fluid into small drops, the
ultrasonic atomizer uses only ultrasonic vibrational energy to generate a gentle, low-velocity spray. Overspray is practically
eliminated, resulting in substantial material savings and reduction in airborn pollution. The liquid can be dispensed to the
atomizing probe (nozzle) by either gravity or a small low-pressure metering pump, and atomized continuously or intermittently. The rate at which the liquid is atomized depends, within limits, solely on the volume that is being delivered onto
the atomizing surface, and the frequency. Typically, the higher the frequency, the lower the processing capability. The
amount of material atomized can be as little as 2 µl/sec. Because the droplets typically drift downward at low velocity
under the influence of gravity, the probe should be mounted with the tip facing downward, and air turbulence kept to a
minimum to mitigate spray pattern distortion. A wide variety of coatings, chemicals, lubricants, and particulate suspensions
can readily be atomized. However, factors such as viscosity, miscibility, and solid content deserve consideration. For optimum atomization, the viscosity should be under 500 cps and the solid concentration kept below 30%. Although lower frequencies are capable of atomizing higher viscosity liquids, because the atomization process depends on setting a liquid film
into motion, typically the higher the viscosity – the lower the flow rate, and the more difficult the application. The atomization of liquids containing long-chained polymer molecules is problematic, even in diluted form, due to the highly cohesive
nature of the material. In many cases, mixtures with particulates can be atomized, because the solids are simply carried
along in the drops. The low transport velocity of the liquid through the probe permits even abrasive slurries to be processed
with negligible erosion of the passageway. Compared with conventional pressurized nozzles, the feed channel running
through the probe and exit orifice are relatively large, and practically uncloggable. Drop size is primarily a function of frequency, and the higher the frequency, the smaller the drop diameter. With water, the median drop size at 20 kHz is 90
microns, and 50 microns at 40 kHz.
SONICS & MATERIALS, INC., 53 CHURCH HILL ROAD, NEWTOWN, CT 06470-1614 USA

1-800-745-1105